ccie preparation-ccie voice lab rack

This web site is about ccie preparation, ccie voice lab rack, cisco ccnp books, cisco ccnp books, cisco com ccie.-All the news about ccie preparation

Sunday, June 15, 2008

virtual lab

Headlines on virtual lab

Bloggers Unite In Acts of Kindness

Thu, 03 Jan 2008 00:32:11 +0000
When we started Bloggers Unite in 2007, it was our belief that the best social networks are born our of a sense of community — people who share common interests and experiences. We knew that bloggers could do good, and do good together. Our most recent challenge proved that to us more than any other ...]

offer] How To Use Switches In Dynamips, use all commands, not just vlan database

Thu, 12 Jun 2008 05:19:48 +0000
All users of dynamips must have figured out by now that you can use NM16-ESW module for using switching commands on router, however, those are really restricted only to vlan database mode, however, not so now

Popular stories sorted by date

IPv6 Ping Test Characters

Fri, 06 Jun 2008 18:45:08 +0000
I recently posted about a strange ping return character:
r5(config-if)#do p 2001:173:1:57::7
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 2001:173:1:57::7, timeout is 2 seconds:
HHHHH
Success rate is 0 percent (0/5)
Props to Geoff for pointing out that this is an IPv6 PING Character:
ping ipv6



Table 41 ping Test Characters (IPv6) 




!


Each exclamation point indicates receipt of a reply.




.


Each period ...]

Automatic Available vs Automatic Work

Sat, 05 Aug 2006 05:21:03 +0000
Automatic Work setting is at the CSQ level (Or at Agent Based Routing settings level) (Default Disabled).
Automatic Available setting is available for each agent. (Default Enabled)
Default settings make the agent go to Ready status immediately.
Automatic Work Settings override Automatic available setting set at agent level, when Automatic work is enabled.  No matter what the Automatic ...]

Understanding IPv6 NAT-PT

Fri, 18 Apr 2008 18:24:18 +0000
IPv6 NAT-PT is to be used with IPv4 to IPv6 migration scenarios and it’s purpose is to provide bi-directional connectivity between IPv4 and IPv6 domains. A dual-stack router with interfaces in both IPv4 and IPv6 networks is capable of performing this task. The difference from classic IPv4 NAT is that translations should be done both ...]


Arriving to conclusions can be considered the most difficult part of any form of writing. We felt the same here with this article on virtual lab. Hope you enjoyed it.
#



virtual lab Products we recommend


Handango Inc.
Higher test scores guaranteed or your money back


ccie lab boot camp
ccie lab bootcamp
|

Labels: